Barometric Pressure Sensor: Testing and Inspection

BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [MZR 2.5]

NOTE:
- The BARO sensor cannot be removed as a single unit. When replacing the BARO sensor, replace it together with the PCM as a single unit.

1. Connect the M-MDS to the DLC-2.

2. Switch the ignition to ON.

3. Verify that the BARO sensor output voltage (PID: BARO) within the specification. On-Board Diagnostic Test Component Tests and General Diagnostics

- If not as specified, replace the PCM. Service and Repair