Programming and Relearning

CAMSHAFT/CRANKSHAFT SYNCHRONIZATION

The camshaft and crankshaft synchronization procedure must be performed after a following component(s) replacement:

- Camshaft
- Camshaft Position Sensor
- Camshaft Sensor Target Magnet
- Crankshaft
- Cylinder Block
- Cylinder Head
- Water Pump
- Timing Belt and Timing Belt Tensioner
- Powertrain Control Module (PCM)

1. Perform camshaft and crankshaft synchronization procedure as follows:
- Connect the DRB III scan tool to the data link (diagnostic) connector. This connector is located in the passenger compartment; at the lower edge of instrument panel; near the steering column.
- Turn the ignition switch on and access the "miscellaneous" screen.
- Select "re-set values" option.
- Perform cam/crank synchronization procedure following directions on DRB III screen.