Body Control Module: Service and Repair

BODY CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the battery ground (negative) cable.

IMPORTANT: You must perform the new body control module (BCM) setup when replacing the BCM. Refer to Control Module References.

2. Remove the left instrument panel insulator.
3. Disconnect the BCM electrical connectors (2,3,4).
4. Remove the BCM (1).

INSTALLATION PROCEDURE




1. Install the BCM (1).
2. Connect the BCM electrical connectors (2,3,4).
3. Install the left instrument panel insulator.
4. Connect the battery ground (negative) cable.
5. Perform the new BCM setup. Programming and Relearning